Tivolite Vintage Bulb
Thea Wall Sconce
Step & Guide
Bare Step Premium
Bare Step Standard
Softstep ll Titanium
Softstep ll TT Plus +
Architectural Lighting - Product Selection Guide
Auditorium & Amphitheater Lighting- Product Selection Guide
Tivoli Representative List - United States
Tivoli Representative List - Canada
Thea Wall Sconce
Auditorium & Amphitheater
Power Supply & Controls
Adjustable extrusion with light focusing lens. Adjustable insert allows for TivoTape to emit a 100, 300, 600, 900 beam angle.
Mounting & Accessories
Easily mounts with zinc or chrome matte clips. End caps available with or without hole for lead wire.
Ideal for lighting surface mount applications such as cabinets, stairs, display cases, niche and accent lighting.
Available Lens: Clear/Frosted UV resistant lens or Economy Lens
Lengths Sold In: 6.5'
Photos provided by KLUS
Various beam angles may be achieved depending on how the fixture is assembled. See the following options.
Option 1: 10° Beam Angle
This option does not use the included insert. Make sure inside channel surface where Tivotape is to be applied is clean, free of all dirt, oil and debris.
Note: Cleaning channel mounting surface with alcohol is recommended.
Step 1: Cut Tivotape™ at recommended cut point, if necessary, to fit channel.
Step 2: Peel off backing tape and apply Tivotape™ directly to the inside surface of Regulor Channel.
Note: Be sure to position Tivotape™ at least .375” away from edge of channel if End Caps will be used.
Prepare Insert before proceeding with subsequent options.
Step 1: Identify shallow side and deep side of Channel Insert.
Step 2: If End Caps will be used, be sure the Channel Insert measures 3/4” shorter than the length of the Regulor Channel. Trim as required.
Option 2: 30° and 60° Beam Angle .
Step 1: Position the Channel Insert with the shallow side up.
Step 2: Make sure insert surface where Tivotape is to be applied is clean, free of all dirt, oil and debris.
Step 3: Peel backing tape from bottom side of Tivotape™ and attach to top surface of insert.
Step 4: Slide insert into channel as shown. Use lower slot in Channel to achieve a 30° beam angle and use the upper slot for a 60° beam angle.
Option 3: 90° Beam Angle.
Step 2: Position the Channel Insert with the deep side up.
Step 3: Make sure surface of insert where Tivotape is to be applied is clean, free of all dirt, oil and debris.
Step 4: Peel backing tape from bottom side of Tivotape™ and attach to top surface of insert.
Step 5: Slide insert into upper slot of channel as shown.
Color is our concern.